GM01 Specification Sheet
GM01 4G Mesh Node

The GXC GM01 Mesh Node enables a G101 or G501 Access Point to wirelessly connect to the GXC Onyx Gateway Node. This is accomplished using self-interference mitigation techniques, allowing access and backhaul carriers to co-exist in CBRS Band 48. Together with GXC's Onyx Platform for orchestration, management, and SAS registration, the GM01 provides coverage extension and rapid deployment in areas where wired infrastructure is unavailable.
Backhaul
Band Support
Band 48 CBRS
Radio Technology
LTE: CAT 12, up to 2 CA, 2x20 MHz
Antenna Configuration
1T2R
Antenna Connector
2 x Type N
TX Power
20 dBm max RMS
RX Sensitivity
-92 dBm per 10 MHz carrier
SIM Support
Dual-SIM, 2FF, external access
Access
Band of Operation
Band 48 CBRS
Antenna Configuration
2T2R
Antenna Connectors: AP Input
2 x Type N
Antenna Connectors: AP Antenna
2 x Type N
Max AP Input Power
33 dBm per port
Antenna Isolation: Access to Backhaul
45 dB minimum
Insertion Loss AP Interface
2.6 dB typical
Hardware Specifications
Power: Nominal Vin
48 VDC
Input Voltage Range
36 V to 60 V
Isolation
Input to Field-GND: 2.5 kVDC
Power Consumption
20 W maximum
AP Data Interface
RJ45 1GbE IEEE-802.3ab, non-PoE
Wireless Diagnostic Interface
Wi-Fi diagnostic AP, 2.4 GHz
Installation
Pole or Wall Mount *
Dimensions
13.9 x 9.7 x 5.3 in
Weight
18.75 lb (8.505 kg)
Environmental Specifications
Operating Temperature
-40°C to +55°C
Storage Temperature
-45°C to +85°C
Humidity
5% to 95% RH
Atmospheric Pressure
751 to 1014 mbar (sea level to 2000 meters altitude)
Water / Dust Ingress
IP66
Operational Vibration (Random)
+12 dB/octave from 5 to 10 Hz, 0.04 m2/s3 from 10 to 50 Hz, -12 dB/octave from 50 to 100 Hz, 3 axes x 30 minutes, per IEC 60068-2-64 (Fh)
Operational Shock
100 half-sine pulses at 50 m/s2 with 11 ms duration each of 6 directions per IEC 60068-2-27 (Ea)
Salt-Fog Corrosion
240 hr at 35°C, 5% NaCl Salt Mist per IEC 60068-2-11 (Ka)
Certifications
FCC part 15 (US) FCC part 96 (US)
Global Part Numbers
GXC-MEN-001
GM01 Mesh Node
The Mounting Kit must be ordered separately. The GXC GM01 is designed to operate in conjunction with a G101 or G501 Access Point, which is required for the GM01 to function.
Specifications and ID are subject to change without notice.
Last updated
Was this helpful?
