Document Overview and Safety Information

The following topics provide overall information about this guide and important safety information.

About this Guide

This guide provides the information you need to install and configure a GXC GM03 Mesh Node. It also includes a general description of the unit, guidelines for using it, an overview of its capabilities and operating instructions.

NOTE: Installation of this device should only be performed by a Certified Professional Installer (CPI) in a fixed outdoor environment per limitations set forth in FCC Part 96 CBRS band, as well as guidelines as summarized by the OnGo Alliance.

Safety Information

For the safety of installation personnel and for the protection of the equipment from damage, please read all safety warnings. If you have any questions concerning the warnings, before installing or powering on the equipment contact GXC.

WARNING: Read the installation instructions before connecting the system to its power source.

WARNING: Equipment installation must comply with local and national electrical codes.

WARNING: This product relies on the existing building or structure for short-circuit (overcurrent) protection. Ensure that the protective device is rated no greater than 20A.

WARNING: Do not operate this wireless network device near unshielded blasting caps or in an explosive environment.

WARNING: In order to comply with the United States Federal Communications Commission (FCC) radio frequency (RF) exposure limits, antennas for a GM03 Mesh Node should be located at a minimum of 20 centimeters (7.9 inches) or more from the body of all persons.